|
Post by sixty9santa on Jul 31, 2008 19:42:02 GMT -5
Hey gang My column shift stick is about to fall of it's column since the roll pin is just barely holding it in place. I know that I could simply hammer it back in, but I'd like to remove and clean her up a bit. Maybe even re-chrome it? So my question is this: How hard is it to remove and put back the columns shift stick? Will there be anything coming with it or any springs flying out? I ask this since I'd much rather put a machine screw in there with a nut instead of a roll pin.
|
|
|
Post by Jeff Roblin on Jul 31, 2008 21:20:57 GMT -5
I found a NOS on Ebay or was it at Carlisle.....either way, my mechanic was doing some work on the car I didn't have time to do, so I just had him swap it out.
|
|